Xerox DocuPrint N24 Service Manual page 899

Replacement
1 Reinstall the bearings onto the ends of the Transport Roll.
2 Slide the rear of the Transport Roll shaft through the bearing hole in the rear of the Transport
frame.
3 Slide the front of the Transport Roll shaft through the bearing hole in the front of the Transport
frame.
4 Insert each bearing into the bearing holes. Use an E Ring at each end of the shaft to secure the
bearings.
5 Reinstall the Transport Roll Guide by first inserting the three latches into the latch openings in the
Transport, then pressing the Guide into place.
6 Reinstall the Transport Gear onto the Transport Roll shaft. Use an E Ring to secure the Gear to
the shaft.
7 Make sure the Transport Drive Belt runs on top of the Gear.
8 Reinstall the Bracket Assembly to the Transport frame, and use two screws to secure the
Assembly.
9 Reinstall the IN Gate Solenoid Assembly.
10 Hook the Tension Spring onto the Bracket Assembly.
11 Make sure that J261 is still connected to the Transport Interlock Sensor.
12 Reinstall the wire harnesses into the harness clips that are attached to the Bracket Assembly.
13 Reinstall the Transport Assembly.
14 Reconnect the Finisher to the Printer.
DocuPrint N24, N32 and N40 Service Manual
3/99
8-461 Options