Rep 8.5.3.18 Bottom Bin Assembly - Xerox DocuPrint N24 Service Manual

Network laser printer

Hide thumbs Also See for DocuPrint N24:

Table of Contents

REP 8.5.3.18 Bottom Bin Assembly

Parts List on PL 8.5.2.5

1 Switch off the printer power and disconnect the AC Power Cord.

2 Remove the Harness Cover (REP 8.5.3.8).

3 Release the three locking tabs and remove the bottom Harness Guide Cover (Figure 8.5.3.18a).

4 Free the wire harnesses in the Harness Guide, from the harness clips.

5 Disconnect J830A, J871, J874A, and J875A (Figure 8.5.3.18a).

6 Remove the screw securing the bottom Harness Guide, and remove the Guide (Figure

7 Remove the two screws securing the bottom of the Bottom Bin Assembly to the Finisher frame

(Figure 8.5.3.18a).

8 Loosen the two screws securing the top of the Assembly to the Finisher frame (Figure 8.5.3.18a).

9 Lift the Bottom Bin Assembly off of the top screws, and remove the Assembly from the frame.

1 Reinstall the Bottom Bin Assembly by hooking the keyhole screw holes at the top of the

Assembly over the two screws on the frame.

2 Use two screws to secure the bottom of the Assembly to the frame.

3 Tighten the two top screws.

4 Route the Bottom Bin Assembly wire harness into the slot in the bottom Harness Guide.

5 Reinstall the bottom Harness Guide, and use one screw to secure it to the frame.

6 Reconnect J830A, J871A, J874A, and J875A.

7 Secure the wire harness into the harness clips.

8 Reinstall the bottom Harness Guide Cover.

9 Reinstall the Harness Cover.

DocuPrint N24, N32 and N40 Service Manual

Table of Contents