Xerox DocuPrint N24 Service Manual page 845

Replacement
1 Reinstall the Eject Bracket Assembly onto the Finisher frame. Ensure the cam follower pin on the
Offset Lever is correctly positioned in the cam in the Exit Bracket Assembly.
2 Use four screws to secure the Assembly.
3 Hook the Tension Spring onto the Eject Bracket Assembly.
4 Reinstall the Harness Bracket Assembly to the Finisher frame, and use three screws to secure
the Bracket.
5 Ensure that J842 to the Set Clamp Sensor did not accidentally become disconnected when the
Harness Bracket Assembly was moved.
6 Reinstall the Offset Home Sensor.
7 Reconnect P863 and replace the harness in the harness clamps
8 Reinstall the Eject Clamp Sensor.
9 Reinstall the Upper Rear Cover.
10 Reconnect the Finisher to the printer.
DocuPrint N24, N32 and N40 Service Manual
3/99
8-407 Options