Rap 7.14 Tray 2 Problem (H1-2) - Xerox DocuPrint N24 Service Manual

RAP 7.14 Tray 2 Problem (H1-2)

1 Slowly side Tray 2 out of Feeder 2. You hear the Tray 2 bottom plate drop as you slide the Tray
out of the Feeder.
Y N
|
Replace Tray 2 (PL 2.1).
2 Enter Diagnostic Mode - 5.4.6 Running a Service Sensor (H/L) Input Test, Level Sensor Detect
(Select tray 2) to check the Tray 2 Lift Up Sensor. Remove Tray 2 from the printer. Pull down on
the Nudger Roll so it clears the Tray 2 Level Sensor. The Control Panel LCD displays H before
you pull down the Nudger Roll. Pull down on the Nudger Roll so it clears the Tray 2 Level Sensor
and press [4]. The Control Panel LCD displays L when you pull down the Nudger Roll.
Y N
|
Check wiring between P/J 408 and P/J 141 (6.3.12). If OK, replace the Tray 2 Lift Up
Sensor (REP 4.2.8).
3 Remove the Lower Rear Cover (REP 4.1.4). Load paper into Tray 2 and install Tray 2 into Feeder
2. Enter Diagnostic Mode 5.4.5 Running a Service Output Test, Lift Up Motor Operation (Select
Tray 2) to check the Tray 2 Lift Up Motor. The Tray 2 Lift Up Motor runs when the Diagnostic
Mode starts.
Y N
|
Check wiring between P/J 408 and P/J 241 (6.3.12). If OK, replace Tray 2 Lift Up Motor
(REP 4.2.1).
4 Replace the Printer Engine Controller PWB (REP 4.10.6).
Repair Analysis Procedures (RAP)
2/2000
7-22 DocuPrint N24, N32, N40, N3225, and N4025