Xerox DocuPrint N24 Service Manual page 636

5 Remove the E-ring securing HCF Drive Gear 1 and slide Gear off the shaft (Figure 8.4.3.4b).
6 Remove the E-ring securing Tray 4 Drive Gear 1 and slide Gears off the shaft (Figure 8.4.3.4b).
7 Remove the Drive Belt from the HCF Drive Pulley.
Replacement
1 Reinstall the Drive Belt over the HCF Drive Pulley.
2 Reinstall the HCF Drive Gear 1 and the Tray 4 Drive Gear 1 onto the respective shafts, and use
one E-ring to secure each gear.
3 Reinstall the Take Away Bracket to the frame, making sure the bearing is still in place on the end
of the Feed Clutch, and use two screws to secure the Bracket.
4 Reinstall the HCF Feed Motor.
5 Reinstall the Rear Cover.
Options
Figure 8.4.3.4b. Drive Gears and HCF Drive Belt
3/99
8-198 DocuPrint N24, N32 and N40 Service Manual