Rep 8.5.3.96 Transport Exit Sensor - Xerox DocuPrint N24 Service Manual

REP 8.5.3.96 Transport Exit Sensor

Parts List on PL 8.5.2.24
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Roll the Finisher away from the printer until it stops.
3 Open the Transport Cover.
4 Carefully lift up on the Transport Exit Sensor Cover while you release the two latches securing
the Cover to the Transport, and remove the Cover.
5 Disconnect J263 from the Transport Exit Sensor.
6 Reach under the Transport and release the latches securing the Sensor the Transport while you
pull the Sensor away from the Transport.
Replacement
1 Open the Transport Cover.
2 Position the Transport Exit Sensor into the Sensor cutout in the bottom of the Transport
Assembly.
3 Reconnect J263 to the Sensor.
4 Reinstall the Transport Exit Sensor Cover by first inserting the two latches into the latch openings
in the Transport, then pressing the Cover into place.
5 Close the Transport Cover.
6 Reconnect the Finisher to the printer.
Options
Figure 8.5.3.96a. Transport Exit Sensor.
3/99
8-464 DocuPrint N24, N32 and N40 Service Manual