Overview - Xerox DocuPrint N24 Service Manual

Network laser printer

Hide thumbs Also See for DocuPrint N24:

Table of Contents

4.0 Overview

Locations given in the Repair Procedures (REPs) assume you are facing the Control Panel with the

orientation illustrated in (Figure 4.0.1).

The following notations apply:

Arrows in the illustrations show direction of movement. Follow the numerical order if the arrows are

The notation Figure X.Y.Z references the illustration corresponding to the REP you are performing.

Numbers in an illustration refer to the corresponding steps in the procedure being performed.

Example, REP 4.1.1, steps 4 and 5 each says to remove a screw. Notice that the screws in the

illustration are labeled 4 and 5, indicating steps 4 and 5.

There are a number of steps you should follow each time before you begin a procedure:

1 Do not use force to remove or install printer components.

2 Use only the screw size and type designated in the REP. The wrong screw could easily damage

tapped holes.

3 Wear a ESD wrist strap to dissipate static electricity, which may damage sensitive electronic

parts, and use a grounded mat when working with PWBs.

4 See Section 6 for the precise location of electrical connectors in the printer.

This manual reflects the configuration of the printer at the time the manual was created. As the printer

matures, the number of screws, bolts, E-Rings, etc. attaching components, the placement of hardware,

the placement of wire runs, or the design of the components may change.

Repair Procedures

Figure 4.0.1 Printer Orientation.

DocuPrint N24, N32 and N40 Service Manual

Table of Contents