REP 8.3.3.9 Envelope Feeder Retard Roll Assembly
Parts List on PL 8.3.2.3
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the Envelope Feeder from the base engine.
3 Remove the Bottom Cover (REP 8.3.3.1).
4 Remove the Top Cover (REP 8.3.3.2).
5 Remove the Front Cover (REP 8.3.3.3).
6 Remove the Weight Arm from the Feeder Assembly.
7 Remove the two screws that secure the Paper Guide to the Upper Cover (Figure 8.3.3.9a).
8 Remove the two K clips from the Retard Shaft (Figure 8.3.3.9b).
9 Remove the E-ring from the Retard Shaft (Figure 8.3.3.9b).
10 Slide the Friction Clutch and Clutch Stopper off of the Retard Shaft.
11 Slide the Feeder Bearing off of the Retard Shaft.
12 Slide the Retard Roll off of the Retard Shaft.
Options
Figure 8.3.3.9a. Paper Guide.
3/99
8-146
DocuPrint N24, N32 and N40 Service Manual