Rap 8.5.7.30 Error Code "Clear Underneath Finisher Bins" Or "Clear Underneath Finisher Elevatr - Xerox DocuPrint N24 Service Manual

RAP 8.5.7.30 Error Code "Clear Underneath Finisher Bins" or "Clear
Underneath Finisher Elevatr"
1 Enter Diagnostic Mode - Input H/L - Finisher/Stacker Sensor Switch - Bin 1 Safety Switch.
Actuate and deactuate the Top Bin Safety Switch. The Control Panel LCD displays H when the
switch is actuated and L when the switch is deactuated.
Y N.
|
Power off printer and troubleshoot (WIR 8.5.5.1) failure of either Top Bin Safety Switch
(Figure 8.5.3.44a) or Middle Bin Safety Switch ((Figure 8.5.3.33a)). If wiring and switches
check ok, replace the Finisher PWB (Figure 8.5.3.83a).
2 Enter Diagnostic Mode - Input H/L - Finisher/Stacker Sensor Switch - Lower Safety Switch to test
Bottom Bin Safety Sensor. The Control Panel LCD displays L when the bin is in the home
position and H when the bin is manually lifted up away from the home position.
Y N
|
Replace the Bottom Bin Safety Sensor (Figure 8.5.3.23a).
3 Enter Diagnostic Mode - Input H/L - Finisher/Stacker Sensor Switch - Upper Limit Switch.
Actuate and deactuate the Upper Limit Switch. The Control Panel LCD displays H when the
switch is actuated and L when the switch is deactuated.
Y N
|
Replace the Upper Limit Switch (Figure 8.5.3.14a).
4 Enter Diagnostic Mode - Output - Finisher Operations - Stacker Elev CCW to lower the Finisher
Bins. Enter Diagnostic Mode - Output - Finisher Operations - Stacker Elev CW to raise the
Finisher Bins. The Finisher Bins actuate the Upper Limit Switch.
Y N
|
Replace the Elevator Motor(Figure 8.5.3.17a).
5 Enter Diagnostic Mode - Input H/L - Finisher/Stacker Sensor Switch - Lower Limit Switch.
Actuate and deactuate the Lower Limit Switch. The Control Panel LCD displays H when the
switch is actuated and L when the switch is deactuated.
Y N
|
Replace the Lower Limit Switch (Figure 8.5.3.13a).
6 Enter Diagnostic Mode - Output - Finisher Operations - Stacker Elev CW to raise the Finisher
Bins. Enter Diagnostic Mode - Output - Finisher Operations - Stacker Elev CCW to lower the
Finisher Bins. The Finisher Bins actuate the Lower Limit Switch.
Y N
|
Replace the Elevator Motor(Figure 8.5.3.17a).
7 Replace the Finisher PWB (Figure 8.5.3.83a). If problem exists, replace the Printer Engine
Controller PWB (REP 4.10.6).
DocuPrint N24, N32 and N40 Service Manual
3/99
8-569 Options