Rep 4.8.4 Exit Gate Solenoid - Xerox DocuPrint N24 Service Manual

REP 4.8.4 Exit Gate Solenoid

Parts List on PL 9.1
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Open the Duplex Unit if one is installed.
3 Remove the Fuser Full Cover (REP 4.1.1).
4 Disconnect the Exit Gate Solenoid inline connector (P/J 210) (Figure 4.8.4a).
5 Remove the two screws that secure the solenoid to the front of the Offset / Exit Assembly (Figure
4.8.4a). Remove the solenoid.
Replacement
1 Assemble in reverse order.
2 Verify proper operation.
DocuPrint N24, N32, N40, N3225, and N4025
Figure 4.8.4a. Exit Gate Solenoid.
2/2000
4-75 Repair Procedures