Rap 7.46 Damaged Prints - Xerox DocuPrint N24 Service Manual

RAP 7.46 Damaged Prints

1 Inspect the paper that is loaded in the Feeder that is having the damage problem. The paper is in
good condition (not wrinkled, creased, or torn).
Y N
|
Replace with fresh, dry paper.
2 Inspect the paper path, between the feed tray and the exit tray, for paper scrap, obstructions, or
broken printer components. The paper path is clear and there are no broken components.
Y N
|
Clear the paper path or replace the broken component.
3 Run a System Controller Test Print (5.5.2.2.2) for Version 1.7X and below, (5.6.2.2.2) for Version
1.8X, or (5.7.2.12.2) for Version 2.0 and switch OFF printer power halfway through the print
cycle. Open the Left Upper Cover. The paper was fed straight.
Y N
|
Go to RAP 7.45.
4 Inspect all of the rolls along the paper path, between the feed tray and the exit tray, for
contamination, wear, or damage. The paper path rolls are free of contamination, wear, or
damage.
Y N
|
Replace any damaged or worn rolls.
5 Run a System Controller Test Print and switch OFF printer power before the sheet of paper
reaches the Fuser. Open the Left Upper Cover. The paper is undamaged.
Y N
|
Replace the EP Cartridge (PL 7.2) and/or the BTR Assembly (REP 4.5.2).
6 Run another System Controller Test Print and switch OFF printer power when the print is halfway
through the Fuser. Open the Left Upper Cover. Examine the paper as it exits the Fuser. The
paper is undamaged as it exits the Fuser.
Y N
|
Replace the Fuser Assembly (REP 4.7.1).
7 Inspect the exit transport area for obstructions or defective rolls. Repair or replace as necessary.
Repair Analysis Procedures (RAP)
PROBLEM
The printed page comes out of the printer either wrinkled, creased, or torn.
2/2000
7-68 DocuPrint N24, N32, N40, N3225, and N4025