Rep 8.5.3.48 Right Rack Cover Assembly - Xerox DocuPrint N24 Service Manual

REP 8.5.3.48 Right Rack Cover Assembly

Parts List on PL 8.5.2.3
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Disconnect the Finisher from the Printer (REP 8.5.3.1).
3 Remove the Harness Cover (REP 8.5.3.8).
4 Remove the Bottom Bin Assembly (REP 8.5.3.18).
5 Remove the Middle Bin Assembly (REP 8.5.3.28).
6 Remove the Top Bin Assembly (REP 8.5.3.38).
7 Remove the Lower Left Cover (REP 8.5.3.6).
8 Remove the four screws securing the Elevator Drive Bracket to the Elevator Hinge Bracket
(Figure 8.5.3.48a).
9 Remove the four screws securing the Elevator Hinge Bracket to the Right Rail Cover (Figure
8.5.3.48a). Remove the Hinge Bracket.
10 Remove the six screws securing the Rail to the two channels of the Finisher Frame (Figure
8.5.3.48a). Lift the Rail up and off of the frame.
11 Remove the seven screws securing the Right Rack Cover to the Finisher Frame (Figure
8.5.3.48a).
12 Pull the Cover away from the frame far enough to disconnect the limit switches.
13 Disconnect J273 (Upper Limit Switch) (Figure 8.5.3.48a).
14 Disconnect J274 (Lower Limit Switch) (Figure 8.5.3.48a).
Replacement
1 Position the Right Rack Cover up to the Finisher Frame.
2 Reconnect J274 (Lower Limit Switch).
3 Reconnect J273 (Upper Limit Switch).
4 Secure the Right Rack Cover with the seven screws.
5 Position the Rail into the two channels of the Finisher Frame. Use the six screws to secure the
Rail to the channels.
6 Reinstall the Elevator Hinge Bracket to the R/H Rack Cover, and use four screws to secure the
Bracket.
7 Use the four screws to secure the Elevator Drive Bracket to the Hinge Bracket.
8 Reinstall the Lower Left Cover.
9 Reinstall the Top Bin Assembly.
10 Reinstall the Middle Bin Assembly.
11 Reinstall the Bottom Bin Assembly.
Options
3/99
8-386 DocuPrint N24, N32 and N40 Service Manual