Xerox DocuPrint N24 Service Manual page 893

Replacement
1 Align the Transport Assembly Drive Belt so the ribbed side of the belt is on the inside.
2 Reinstall one end of Transport Assembly Drive Belt over the Idler Gear shaft.
3 Reinstall the Idler Gear, making sure the Drive Belt loops around the rear teeth of the Idler Gear.
4 Route the Drive Belt with the ribbed side of the Belt always facing a Transport Gear.
5 Reinstall the Idler Gear Support, and use one E Ring to secure it to the frame.
6 Hook the Idler Gear Spring onto the Transport frame.
7 Reinstall the Tension Bracket onto the Transport frame, making sure the Tension Roll rides on
the ribbed side of the belt. Use two screws to secure the Tension Bracket to the frame.
8 Reinstall the Bracket Assembly onto the Transport frame, and use two screws to secure the
Bracket.
9 Reinstall the IN Gate Solenoid Assembly to the Bracket Assembly, and use two screws to secure
the Solenoid to the Bracket.
10 Make sure that J261 is still connect to the Transport Interlock Sensor.
11 Reroute the wire harnesses through the clips that are attached to the Bracket Assembly.
12 Reconnect J260 to the IN Gate Interlock Sensor.
13 Hook the Tension Spring onto the Tension Bracket.
14 Reinstall the Transport Assembly.
15 Reconnect the Finisher to the Printer.
DocuPrint N24, N32 and N40 Service Manual
3/99
8-455 Options