Xerox DocuPrint N24 Service Manual page 988
Network laser printer
Hide thumbs
Also See for DocuPrint N24:
- System administrator manual (398 pages) ,
- User manual (100 pages) ,
- Function manual (15 pages)
Table of Contents
Advertisement
6 Enter Diagnostic Mode -
- Input H/L - Finisher Stacker Sensor/Switch - Bin 1 Half Sr, for Top Bin.
- Input H/L - Finisher Stacker Sensor/Switch - Bin 2 Half Sr, for Middle Bin.
- Input H/L - Finisher Stacker Sensor/Switch - Bin 3 Half Sr, for Bottom Bin.
Manually insert and remove paper from between sensor arms of the Bin Half Sensor. The Control
Panel LCD displays L or H as the paper is inserted and removed.
Y
N
|
Replace the Bin Half Sensor (REP 8.5.3.40) (REP 8.5.3.30) (REP 8.5.3.20).
7 Enter Diagnostic Mode -
- Input H/L - Finisher Stacker Sensor/Switch - Bin 1 Full Sr, for Top Bin.
- Input H/L - Finisher Stacker Sensor/Switch - Bin 2 Full Sr, for Middle Bin.
- Input H/L - Finisher Stacker Sensor/Switch - Bin 3 Full Sr, for Bottom Bin.
Manually insert and remove paper from between sensor arms of the Bin Full Sensor. The Control
Panel LCD displays L or H as the paper is inserted and removed.
Y
N
|
Replace the Bin Half Sensor (REP 8.5.3.40) (REP 8.5.3.30) (REP 8.5.3.20).
8 Enter Diagnostic Mode -
- Input H/L - Finisher Stacker Sensor/Switch - Bin 1 Lo Limit Sw, for Top Bin.
- Input H/L - Finisher Stacker Sensor/Switch - Bin 2 Lo Limit Sw, for Middle Bin.
- Input H/L - Finisher Stacker Sensor/Switch - Bin 3 Lo Limit Sw, for Bottom Bin.
Manually insert and remove paper from between sensor arms of the Bin Lower Limit Sensor. The
Control Panel LCD displays L or H as the paper is inserted and removed.
Y
N
|
Replace the Bin Lower Limit Sensor (REP 8.5.3.41) (REP 8.5.3.31) (REP 8.5.3.21).
9 Enter Diagnostic Mode -
- Output - Finisher Operations - Stacker T 1 CW, to check the Top Bin.
- Output - Finisher Operations - Stacker T 2 CW, to check the Middle Bin.
- Output - Finisher Operations - Stacker T 3 CW, to check the Bottom Bin.
Enter Diagnostic Mode -
- Output - Finisher Operations - Stacker T 1 CCW, to check the Top Bin.
- Output - Finisher Operations - Stacker T 2 CCW, to check the Middle Bin.
- Output - Finisher Operations - Stacker T 3 CCW, to check the Bottom Bin.
The Belt always drives the Limit Actuator on to Upper or Lower Limit Sensor.
Y
N
|
Go to step 11.
10 Problem Solved.
11 Replace the Finisher PWB (REP 8.5.3.83). The error code reappears.
Y
N
|
Problem solved.
12 Replace the Printer Engine Controller PWB (REP 4.10.6).
Options
3/99
8-550
DocuPrint N24, N32 and N40 Service Manual
Advertisement
Chapters
Table of Contents
