Rep 8.2.3.12 In Gate Solenoid - Xerox DocuPrint N24 Service Manual

REP 8.2.3.12 IN Gate Solenoid

Parts List on PL 8.2.2.6
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the Mailbox Rear Cover Assembly (REP 8.2.3.3).
3 Remove Mailbox from mounting frame and position it so it rests on the Front Cover.
4 Disconnect P/J 812 (In Solenoid) from the Mailbox Control PWB (Figure 8.2.3.12a).
NOTE: Use care not to lose the IN Gate Solenoid Spring or the two small brass screws.
5 Remove the two screws securing the Bracket to the frame, and remove the Bracket (Figure
8.2.3.12a).
6 Remove the two screws securing the IN Gate Solenoid to the Rear Lower Cover (Figure
8.2.3.12a).
7 Slide the Solenoid plunger out of the IN Gate Link and remove the IN Gate Solenoid from the
Mailbox frame (Figure 8.2.3.12a).
DocuPrint N24, N32 and N40 Service Manual
Figure 8.2.3.12a. IN Gate Solenoid
3/99
8-99 Options