Accessing A Major Menu - Xerox DocuPrint N24 Service Manual

NOTE: #3 Only Available when the Hard Drive Option is installed.
NOTE: #4 Only Available when the 100MHz Ethernet Card PWB is installed.
NOTE: #5 Only Available when the High Capacity Feeder Option is installed.
NOTE: #6 Only Available when the Duplex Option is installed.
NOTE: #7 Only Available when the Finisher Option is installed.
NOTE: #8 Only Available when the Mailbox Option is installed.

5.6.2 Accessing a Major Menu

1 From the Ready condition, press [1] once (Figure 5.6.2a).
2 Press[1] or [5] to scroll through the major menus.
3 Press [1] or [5] until the desired major menu is displayed.
Each of the major menus has a number of submenus listed under them.
Press the [2] or [6] to scroll through the submenus.
4 Press the [2] or [6] until the desired submenu is displayed.
In some cases you will have selections from the submenus.
You will now be at the lowest level of the menu. At this level you set, change, or adjust the feature
or option you selected.
5 If a selection exists, press [3] or [7] to scroll through the selections.
6 If you need to go back to the submenu press either [2] or [6].
7 If you need to go back to one of the major menus, press either [1] or [5].
8 When the desired setting is displayed, press [4] to "save" your setting.
9 When you have completed all settings, press [0] to return the printer to the "Ready" condition.
The following tables list all the possible menu paths for each major menu.
DocuPrint N24, N32 and N40 Service Manual
Figure 5.6.2a. Control Panel.
3/99
5-49 General Procedures and Information