REP 4.8 Offset / Exit Assembly
REP 4.8.1 Offset / Exit Assembly
Parts List on PL 9.1
Removal
1 Switch off the printer power and disconnect the AC Power Cord.
2 Remove the Fuser Full Cover (REP 4.1.1).
3 Remove the Rear Cover Assembly (REP 4.1.3).
4 Open the Duplex Unit, if installed.
5 Open the Upper Left Cover.
6 Remove the four P/Js that are connected (at the rear) to the Offset / Exit Assembly (Figure
4.8.1a).
7 Remove the three screws (one screw at the front, next to the solenoid, and two screws at the
rear) securing the Offset / Exit Assembly to the printer frame (Figure 4.8.1a).
8 Lift the Offset / Exit Assembly up and off of the printer frame.
DocuPrint N24, N32, N40, N3225, and N4025
Figure 4.8.1a. Offset / Exit Assembly.
2/2000
4-71
Repair Procedures