Rap 8.3.7.2 Error Code "Paper Jam / Clear Area A - Xerox DocuPrint N24 Service Manual

RAP 8.3.7.2 Error Code "Paper Jam / Clear Area A"

1 Inspect the paper path for paper scraps that may cause a paper jam. The paper path is free of
paper scraps.
Y N
|
Clean the paper path.
2 Inspect the envelopes that are loaded in the Envelope Tray. The envelopes are smooth (not
wrinkled) and undamaged.
Y N
|
Replace the envelopes with new envelopes.
3 Enter Diagnostic Mode - Input H/L, REGI Sensor Detect. Insert a sheet of paper into the
Registration Sensor and press [4], then remove the sheet of paper and press [4]. The Control
Panel LCD displays "IS WITH PAPER" when you insert the paper into the Registration Sensor
and "IS WITHOUT PAPER" when the paper is removed.
Y N
|
Check the wiring between P/J 100 and P/J459 (6.3.14). If OK, replace the Registration
Sensor (REP 4.4.2).
4 Enter Diagnostic Mode - Input H/L, T/A Roll Sensor Detect (Select Roll 2). Insert a sheet of paper
into the Tray 2 Take Away Sensor and press [4], then remove the sheet of paper and press [4].
The Control Panel LCD displays "IS WITH PAPER" when you insert the paper into the Tray 2
Take Away Sensor and "IS WITHOUT PAPER" when the paper is removed.
Y N
|
Check the wiring between P/J 143 and P/J 408 (6.3.12). If OK, replace the Tray 2 Take
Away Sensor (PL 5.2).
5 Enter Diagnostic Mode - Input H/L, ENV Feedout Sensor Detect. Insert a sheet of paper into the
Envelope Feed Sensor and press [4], then remove the sheet of paper and press [4]. The Control
Panel LCD displays "IS WITH PAPER" when you insert the paper into the Feed Sensor and "IS
WITHOUT PAPER" when the paper is removed.
Y N
|
Check the wiring between P/J 132 and P/J 702 (WIR 8.3.5.1). If OK, replace the Envelope
Feed Sensor (PL 8.3.2.3).
6 Enter Diagnostic Mode - Output Test, ENV Feed Motor Operation to start the Envelope Feeder
Motor. The Envelope Feeder Motor runs when the Output Test starts.
Y N
|
Go to step 10.
7 With Output Test, ENV Feed Motor Operation, enter Output Test, Feed Clutch Operation (Select
(SMH/ENV) to actuate the Envelope Feed Clutch. The Envelope Feed Clutch energizes when
Output Test starts.
Y N
|
Replace the Envelope Feed Clutch (PL 8.3.2.2).
DocuPrint N24, N32 and N40 Service Manual
3/99
8-159 Options