Vlan-Stack Dot1P-Mapping - Dell S6000 Reference Manual

Dell#

vlan-stack dot1p-mapping

Map C-Tag dot1p values to a S-Tag dot1p value. You can separate the C-Tag values by commas and
dashed ranges are permitted. Dynamic mode CoS overrides any Layer 2 QoS configuration in case of
conflicts.
S6000
Syntax
vlan-stack dot1p-mapping c-tag-dot1p values sp-tag-dot1p value
Parameters
c-tag-dot1p
value
sp-tag-dot1p
value
Defaults none
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.7.0
Version 8.3.1.0
1442
M Gi 13/4
5 Active M Po1(Gi 13/14-15)
M Gi 13/18
M Gi 13/5
Enter the keyword c-tag-dot1p then the customer dot1p
value that is mapped to a service provider do1p value. The
range is from 0 to 7.
Enter the keyword sp-tag-dot1p then the service provider
dot1p value. The range is from 0 to 7.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
VLAN Stacking