Port-Pipes; Auto-Negotiation On Ethernet Interfaces - Dell S4820T Configuration Manual

Hide thumbs Also See for S4820T:

Table of Contents

Layer 2 Overhead

Untagged Packet with VLAN-Stack Header

Tagged Packet with VLAN-Stack Header

Link MTU and IP MTU considerations for port channels and VLANs are as follows.

Port Channels:

All members must have the same link MTU value and the same IP MTU value.

The port channel link MTU and IP MTU must be less than or equal to the link MTU and IP MTU values

configured on the channel members.

For example, if the members have a link MTU of 2100 and an IP MTU 2000, the port channel's MTU

values cannot be higher than 2100 for link MTU or 2000 bytes for IP MTU.

All members of a VLAN must have the same IP MTU value.

Members can have different Link MTU values. Tagged members must have a link MTU 4–bytes higher

than untagged members to account for the packet tag.

The VLAN link MTU and IP MTU must be less than or equal to the link MTU and IP MTU values

configured on the VLAN members.

For example, the VLAN contains tagged members with Link MTU of 1522 and IP MTU of 1500 and

untagged members with Link MTU of 1518 and IP MTU of 1500. The VLAN's Link MTU cannot be higher

than 1518 bytes and its IP MTU cannot be higher than 1500 bytes.

Port-Pipes

A port pipe is a Dell Networking-specific term for the hardware path that packets follow through a

Port pipes travel through a collection of circuits (ASICs) built into line cards and RPMs on which various

processing events for the packets occur. One or two port pipes process traffic for a given set of physical

interfaces or a port-set.

By default, auto-negotiation of speed and duplex mode is enabled on 10/100/1000 Base-T Ethernet

interfaces. Only 10GE interfaces do not support auto-negotiation.

When using 10GE interfaces, verify that the settings on the connecting devices are set to no auto-

negotiation.

NOTE: When you use a copper SFP2 module with catalog number GP-SFP2-1T in the S25P model,

you can manually set its speed with the speed command. When the speed is set to 10Mbps or

100Mbps, you can execute the duplex command.

The local interface and the directly connected remote interface must have the same setting, and auto-

negotiation is the easiest way to accomplish that, as long as the remote interface is capable of auto-

negotiation.

Difference Between Link MTU and IP MTU