Address Area - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

address area

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] address { ipAddress | unnumbered interfaceType interfaceSpecifier }
area { areaId | areaIdInt }
Command introduced before JunosE Release 7.1.0.
Creates an interface on which OSPF runs in the specified area, on top of the IP interface
at the specified IP address. Uses the default values. The no version deletes OSPF
interfaces. If the OSPF network was previously specified with the network area command,
the OSPF interface already exists, and you do not need to use this command, unless you
want to change the area of the OSPF interface to an area different from the one specified
by the network area command.
NOTE: Before you issue this command, you must first configure an interface with the
IP address specified by ipAddress or an interface configured as unnumbered.
You must issue this command before issuing any other OSPF address command.
ipAddress—IP address of the interface on which OSPF will be run
unnumbered—Configures OSPF on an unnumbered interface
interfaceType—Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
areaId—OSPF area ID in IP address format
areaIdInt—OSPF area ID as a decimal value in the range 1–4294967295
Router Configuration
Chapter 2: A Commands
85