Address-Family - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

address-family

Syntax
Release Information
Description
Options
94
For BGP:
[ no ] address-family { { ipv4 | ipv6 } [ unicast | multicast
| [ unicast ] vrf vrfName ] |
{ vpnv4 | vpnv6 } [ unicast ] | l2vpn [ signaling ] | route-target [ signaling ] |
vpls vplsName | vpws vpwsName }
For IS-IS:
[ no ] address-family ipv6 [ unicast | multicast | unicast multicast ]
For RIP:
[ no ] address-family ipv4 [ unicast ] vrf vrfName
Command introduced before JunosE Release 7.1.0.
l2vpn and signaling keywords added in JunosE Release 7.1.0.
vpls keyword and vplsName variable added in JunosE Release 7.1.0.
vpws keyword and vpwsName variable added in JunosE Release 8.1.0.
route-target signaling keywords and IS-IS IPv6 version added in JunosE Release 8.2.0.
For BGP, configures the router to exchange addresses for the specified address family.
This command takes effect immediately.
For the IPv4 address family, configures the router or a specific VRF to exchange IPv4
addresses in unicast, multicast, or VPN mode.
For the IPv6 address family, configures the router or a specific VRF to exchange IPv6
addresses in unicast, multicast, or VPN mode.
For the L2VPN address family, configures a router to exchange layer 2 NLRI for all VPLS
instances and all L2VPN (VPWS) instances.
For the VPLS address family, configures the router to exchange layer 2 NLRI for the
VPLS address family for a specified VPLS instance.
For the VPWS address family, configures the router to exchange layer 2 NLRI for the
VPWS address family for a specified L2VPN (VPWS) instance.
For the route-target address family, configures the router to exchange route-target
membership NLRI (RT-MEM-NLRI) that includes information about membership in
VPN route-target extended communities.
For IS-IS, configures IS-IS to exchange IPv6 addresses.
For RIP, configures RIP in a specific VRF to exchange IPv4 addresses.
For all routing protocols, the no version removes the address family.
ipv4—Specifies sessions that carry standard IPv4 address prefixes (default)
ipv6—Specifies sessions that carry IPv6 address prefixes
Copyright © 2010, Juniper Networks, Inc.