address dead-interval
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] address { ipAddress | unnumbered interfaceType interfaceSpecifier }
dead-interval deadInterval
Command introduced before JunosE Release 7.1.0.
Sets the time period that the router's neighbors should wait without seeing hello packets
from the router before they declare the router to be down. The no version resets the dead
interval to its default.
NOTE: You must issue the address area command before issuing this command.
ipAddress—OSPF interface address previously specified with the address command
unnumbered—Indicates that OSPF is running on an unnumbered interface previously
specified with the address command
interfaceType—Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
deadInterval—Number in the range 0–2147483647 seconds; default value is 40 seconds
Router Configuration
Chapter 2: A Commands
93