Address Send Version - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

address send version

Syntax
Release Information
Description
Options
Mode
104
address { ipAddress | unnumbered interfaceType interfaceSpecifier }
send version { 1 | 2 | 1 2 | 2 1 | off }
no address [ ipAddress | unnumbered interfaceType interfaceSpecifier ] send version
Command introduced before JunosE Release 7.1.0.
Restricts the RIP version that the router can send on an interface. The no version sets
the interface back to the default value, sending only RIP version 1.
ipAddress—Address of IP interface where RIP will be run
unnumbered—Specifies that RIP will be run on an unnumbered interface
interfaceType—Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
1—Specifies RIP version 1 only
2—Specifies RIP version 2 only
1 2—Specifies RIP version 1 and version 2
2 1—Specifies RIP version 2 and version 1
off—Turns reception off
Address Family Configuration, Router Configuration
Copyright © 2010, Juniper Networks, Inc.