Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual page 139

Chapter 2: A Commands
multicast—Specifies multicast prefixes
unicast—Specifies unicast prefixes (default)
vrfName—Name of the VRF; string of 1–32 alphanumeric characters
vpnv4—Specifies sessions that carry customer VPN-IPv4 prefixes, each of which has
been made globally unique by adding an 8-byte route distinguisher
vpnv6—Specifies sessions that carry customer VPN-IPv6 prefixes, each of which has
been made globally unique by adding an 8-byte route distinguisher
l2vpn—Specifies sessions that carry L2VPN reachability information
l2vpn signaling—Specifies BGP signaling of L2VPN reachability information; currently,
you can omit the signaling keyword with no adverse effects
route-target—Specifies sessions that carry route-target membership information
route-target signaling—Specifies BGP signaling of route-target membership information;
currently, this can be omitted with no adverse effects
vplsName—Name of a VPLS instance for which you are specifying the L2VPN address
family; must be issued for each separate VPLS instance
vpwsName—Name of a layer 2 VPN (VPWS) instance for which you are specifying the
L2VPN address family; must be issued for each separate L2VPN instance
Mode Router Configuration
Related Topics Configuring BGP Signaling for L2VPNS and Configuring BGP Signaling for VPLS in the
JunosE BGP and MPLS Configuration Guide
Copyright © 2010, Juniper Networks, Inc. 95