Adapter Disable - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

adapter disable

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
adapter disable adapterSpecifier
Command introduced in JunosE Release 7.1.0.
Disables the IOA installed in the specified IOA bay. There is no no version.
NOTE: For IOAs that support hot-swapping, issuing this command does not reboot the
line module. For IOAs that do not support hot-swapping, issuing this command reboots
the line module associated with the IOA, but it does not disable it.
To disable the line module and its associated IOAs, issue the slot disable command.
adapterSpecifier—Particular IOA in the format slot/adapter:
slot—Number of the chassis slot; for E120 routers, in the range 0–5; for E320 routers,
in the range 0–5 or 11–16
adapter—Identifier for the IOA within the chassis slot, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router) or the upper
IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or the lower
IOA bay (E320 router).
Global Configuration
Chapter 2: A Commands
81