Aaa Tunnel Tx-Connect-Speed-Method - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

aaa tunnel tx-connect-speed-method

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
aaa tunnel tx-connect-speed-method { static-layer2 | dynamic-layer2
| qos | actual }
no aaa tunnel tx-connect-speed-method
Command introduced in JunosE Release 8.0.0.
Configures the method used to calculate the transmit connect speed of the subscriber's
access interface for establishing a tunneled L2TP session associated with a virtual router.
This speed is reported in L2TP Transmit (TX) Speed AVP 24. The router uses the
calculation method specified with the aaa tunnel tx-connect-speed-method command
if the tunnel attributes returned from an AAA domain map, an AAA tunnel group, or a
RADIUS authentication server do not include the transmit connect speed calculation
method. The no version removes configuration of the transmit connect speed calculation
method from the tunneled L2TP sessions associated with the virtual router.
static-layer2—Calculates the transmit connect speed of the subscriber's access
interface based on statically configured settings for the underlying layer 2 interface
dynamic-layer2—Calculates the transmit connect speed of the subscriber's access
interface based on dynamically configured settings for the underlying layer 2 interface
qos—Calculates the transmit connect speed of the subscriber's access interface based
on settings determined by QoS
actual—Calculates the transmit connect speed of the subscriber's access interface as
the lesser of the dynamic-layer2 value or the qos value
Global Configuration
Chapter 2: A Commands
73