Enabling E-Lmi On An Interface And Mapping Ce Vlan Ids To An Evc - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

JUNOS 10.1 Network Interfaces Configuration Guide
You can configure an EVC by including the
ethernet]

Enabling E-LMI on an Interface and Mapping CE VLAN IDs to an EVC

To configure E-LMI, include the
hierarchy level:
You can set the status counter to count consecutive errors using the
count
counter is used to determine if E-LMI is operational or not. The default value is 4.
You can set the
ethernet lmi]
You can enable an interface and set its options for use with E-LMI using the
name
and
name for the UNI. If
interface name
You can specify the CE-VLAN ID/EVC map type using the
option. The options are
multiplexing is with no bundling. The default type is
To specify the EVC that an interface uses, use the
protocols oam ethernet lmi interface name]
718
Configuring Ethernet Local Management Interface
hierarchy level:
[edit protocols oam ethernet]
evcs evc-id {
evc-protocol (
<cfm (<management-domain name> <management-association name> )
|<< vpls (routing-instance name>>>
remote-uni-count <number>; # Optional, defaults to 1
multipoint-to-multipoint;
# Optional, defaults to point-to-point if remote-uni-count is 1
}
}
[edit protocols oam ethernet]
lmi {
polling-verification-timer value;
# Polling verification timer (T392), defaults to 15 seconds
status-counter count; # Status counter (N393), defaults to 4
interface name {
evc evc-id {
default-evc;
vlan-list [ vlan-ids ];
}
evc-map-type (all-to-one-bundling | bundling | service-multiplexing);
polling-verification-time value; # Optional, defaults to global value
status-counter count; # Optional, defaults to global value
uni-id value; # Optional, defaults to interface-name
}
}
statement at the [edit protocols oam ethernet lmi]
polling-verification-timer value
hierarchy level. The default value is 15 seconds.
statement at the
[edit protocols oam ethernet lmi]
ae interfaces are supported. You can use the interface
is not configured, it defaults to the name variable of
uni-id
.
all-to-one-bundling
evcs statement at the
)) {
statement at the
lmi [edit protocols oam ethernet]
hierarchy level. The status
statement at the
hierarchy level. Only
evc-map-type type
, , or
bundling service-multiplexing
all-to-one-bundling
evc evc-id
hierarchy level. You can specify an interface
[edit protocols oam
status-counter
[edit protocols oam
interface
, ,
ge xe
uni-id option to specify a
interface
. Service
.
statement at the
[edit