Compatibility-Mode - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

JUNOS 10.1 Network Interfaces Configuration Guide

compatibility-mode

compatibility-mode (adtran | digital-link | kentrox | larscom | verilink) <subrate value>;
Syntax
Hierarchy Level [edit interfaces interface-name e3-options],
[edit interfaces interface-name t3-options]
Statement introduced before JUNOS Release 7.4.
Release Information
Configure the E3 or T3 interface to be compatible with the channel service unit (CSU)
Description
at the remote end of the line.
If you omit this option, the full E3 or T3 rate is used.
Default
adtran
Options
digital-link
kentrox
larscom
verilink
NOTE: Verilink configuration is not functional if an IQ interface is paired with an IQE
interface.
subrate value
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics
1028
compatibility-mode
—For T3 IQ interfaces only, configure compatibility with Adtran CSUs.
—Configure compatibility with Digital Link CSUs. If you include this option
on an E3 interface, you must also disable payload scrambling.
—Configure compatibility with Kentrox CSUs. Kentrox subrate is valid for E3
IQ and T3 IQ interfaces only.
—For T3 and T3 IQ interfaces only, configure compatibility with Larscom
CSUs.
—For T3 IQ and T3 IQE interfaces only, configure compatibility with Verilink
CSUs.
—Subrate of the E3 or T3 line.
Range: For Kentrox CSUs on E3 IQ interfaces and T3 IQ interfaces the subrate
value must match the value configured on the CSU. Each increment of the subrate
value corresponds to a rate increment of about 0.5 Mbps.
Configuring the E3 CSU Compatibility Mode on page 571
Configuring the T3 CSU Compatibility Mode on page 590
payload-scrambler on page 1331