Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 848

JUNOS 10.1 Network Interfaces Configuration Guide
oam ethernet link-fault-management interface interface-name event-thresholds]
level:
Disabling the Sending of Link Event TLVs
You can disable the sending of link event TLVs.
To disable the monitoring and sending of PDUs containing link event TLVs in periodic
PDUs, include the
link-fault-management interface interface-name negotiation-options]
Detecting Remote Faults
Fault detection is either based on flags or fault event type, length, and values (TLVs)
received in OAM protocol data units (PDUs). Flags that trigger a link fault are:
The link event TLVs are sent by the remote DTE by means of event notification PDUs.
Link event TLVs are:
Configuring an OAM Action Profile
You can create an action profile to define event fault flags and thresholds and the
action to be taken. You can then apply the action profile to one or more interfaces.
To configure an action profile, include the
oam ethernet link-fault-management]
778
Disabling the Sending of Link Event TLVs
[edit protocol oam ethernet link-fault-management interface interface-name]
event-thresholds {
frame-error count;
frame-period count;
frame-period-summary count;
symbol-period count;
}
no-allow-link-events
[edit protocol oam ethernet link-fault-management interface interface-name
negotiation-options]
no-allow-link-events;
Critical Event
Dying Gasp
Link Fault
Errored Symbol Period Event
Errored Frame Event
Errored Frame Period Event
Errored Frame Seconds Summary Event
action-profile profile-name {
statement at the
[edit protocols oam ethernet
action-profile statement at the
hierarchy level:
hierarchy
hierarchy level:
[edit protocols