Configuring Fractional T1 Iq Interfaces; Example: Configuring Fractional T1 Iq Interfaces; Configuring Link Pic Failover On Channelized Oc3 Iq And Iqe Interfaces - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

JUNOS 10.1 Network Interfaces Configuration Guide
Remote router:

Configuring Fractional T1 IQ Interfaces

By default, all the time slots on a channelized T1 interface are used. To configure a
fractional T1 interface on a Channelized OC3 IQ or IQE PIC, you must perform the
following tasks:
1.
2.
For channelized T1 IQ interfaces, the time-slot range is from 1 through 24. You can
designate any combination of time slots. To configure ranges, use hyphens. To
configure discontinuous time slots, use commas. Do not include spaces. For more
information, see "Configuring Fractional T1 Time Slots" on page 585.

Example: Configuring Fractional T1 IQ Interfaces

Configure a fractional T1 interface that uses time slots 1 through 5 and 10:
For a full configuration example, see the JUNOS Feature Guide.

Configuring Link PIC Failover on Channelized OC3 IQ and IQE Interfaces

For Channelized OC3 IQ or IQE PICs used as linking PICs in redundant LSQ
configurations, you can inhibit the router from sending PPP termination-request
470
Configuring Fractional T1 IQ Interfaces
bert-period 30;
}
}
}
[edit interfaces]
ct1-0/0/0:2:2 {
partition 1 timeslots 1-10 interface-type ds;
t1-options {
loopback remote;
}
}
Configure a T1 interface on the Channelized OC3 IQ or IQE PIC. For more
information, see "Configuring T1 and NxDS0 Interfaces" on page 466.
Configure the number of time slots allocated to the T1 IQ interface by including
the statement at the
timeslots
hierarchy level:
[edit interfaces t1-fpc/pic/port<:channel> t1-options]
timeslots time-slot-range;
[edit interfaces coc3-0/0/0]
partition 1 oc-slice 1 interface-type coc1;
[edit interfaces coc1-0/0/0:1]
partition 1 interface-type t1;
[edit interfaces t1-0/0/0:1:1 t1-options]
timeslots 1-5,10;
[edit interfaces t1-fpc/pic/port<:channel> t1-options]