Example: Configuring Channelized T3 Iq Interfaces - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

JUNOS 10.1 Network Interfaces Configuration Guide
The statements in the
are ignored if configured on other channels.
To specify options for each of the T1 channels, include the
the
For T1 channels on a channelized T3 interface, the
only for channel 0; it is ignored if included in the configuration of channels 1 through
11. The clock source configured for channel 0 applies to all channels on the
channelized T3 interface. The individual T1 channels use a gapped 45-MHz clock as
the transmit clock. When you configure the clock source for a channelized
interface—
statement at the
information, see "Clock Sources on Channelized Interfaces" on page 398.
For information about Frame Relay DLCI limitations for channelized interfaces, see
"Data-Link Connection Identifiers on Channelized Interfaces" on page 396. For more
information about Frame Relay DLCIs, see "Configuring a Point-to-Point Frame Relay
Connection" on page 388. For more information about DLCI sparse mode, see the
JUNOS System Basics Configuration Guide.
For more information about specific parameters, see "T1 Interfaces Overview" on
page 577 and "T3 Interfaces Overview" on page 587. For a configuration example, see
"Examples: Configuring Channelized DS3-to-DS1 Interfaces" on page 500.

Example: Configuring Channelized T3 IQ Interfaces

Configure a channelized T3 interface as an unpartitioned, clear channel.
Configuring a T3
Interface
Figure 48 on page 497 shows the following interfaces on a Channelized DS3 IQ or
Configuring NxDS0 and
IQE PIC:
T1 Interfaces
496
Example: Configuring Channelized T3 IQ Interfaces
t3-options
[edit interfaces interface-name]
[edit interfaces interface-name]
t1-options {
byte-encoding (nx56 | nx64);
fcs (16 | 32);
framing (sf | esf);
idle-cycle-flag (flags | ones);
loopback (local | payload | remote);
start-end-flag (filler | shared);
timeslots time-slot-number;
}
ds-fpc/pic/port :0
[edit chassis]
[edit interfaces]
ct3-5/0/0 {
no-partition interface-type t3;
}
A channelized T1, which is partitioned into NxDS0 interfaces
T1 interfaces
hierarchy are supported only for channel 0; they
hierarchy level:
clocking
, for example—you must also include the
hierarchy level, and specify channel group 0. For more
t1-options statement at
statement is supported
channel-group