Table 72: Interface Status Tlv Values - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

Table 72: Interface Status TLV Values

Mnemonic
isUp
isDown
isTesting
isUnknown
isDormant
isNotPresent
isLowerLayerDown
Configuring Interface Status TLV
The JUNOS Software provides configuration support for the Interface Status TLV,
thereby allowing operators to control the transmission of this TLV in CCM PDUs
through configuration at the continuity-check level.
NOTE: This configuration is not mandated by IEEE 802.1ag; rather it is provided to
give more flexibility to the operator. The JUNOS Software receives and processes
CCMs with the Interface Status TLV, regardless of this configuration.
The interface status TLV configuration is shown below:
Chapter 43: Configuring IEEE 802.1ag OAM Connectivity-Fault Management
Interface Status
up
down
testing
unknown
dormant
notPresent
lowerLayerDown
protocols {
oam {
ethernet {
connectivity-fault-management {
maintenance-domain identifier {
level number;
maintenance-association identifier {
continuity-check {
interval number;
loss-threshold number;
hold-interval number;
interface-status-tlv; # Sets the interface status TLV
}
}
}
}
}
}
}
Configuring Port Status TLV and Interface Status TLV
Value
1
2
3
4
5
6
7
729