Configuring A Pppoe Interface; Configuring The Pppoe Underlying Interface; Identifying The Access Concentrator; Configuring The Pppoe Automatic Reconnect Wait Timer - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

JUNOS 10.1 Network Interfaces Configuration Guide
Configuring PPPoE Encapsulation on an ATM-over-ADSL Interface
To configure the PPPoE encapsulation on a ATM-over-ADSL interface, perform the
following steps:
1.
2.
You can include this statement at the following hierarchy levels:

Configuring a PPPoE Interface

832
Configuring PPPoE
[edit interfaces pp0 unit logical-unit-number]
[edit logical-systems logical-system-name interfaces pp0 unit logical-unit-number]
Include the statement at the
encapsulation
level, and specify ethernet-over-atm
[edit interfaces pp0]
encapsulation ethernet-over-atm;
Configure LLC encapsulation on the logical interface by including the
statement and specifying
encapsulation ppp-over-ether-over-atm-llc;
[edit interfaces pp0 unit logical-unit-number]
[edit logical-systems logical-system-name interfaces pp0 unit logical-unit-number]
Configuring the PPPoE Underlying Interface on page 833
Identifying the Access Concentrator on page 833
Configuring the PPPoE Automatic Reconnect Wait Timer on page 833
Configuring the PPPoE Service Name on page 834
Configuring the PPPoE Server Mode on page 834
Configuring the PPPoE Client Mode on page 834
Configuring the PPPoE Source and Destination Addresses on page 834
Deriving the PPPoE Source Address From a Specified Interface on page 835
Configuring the PPPoE IP Address by Negotiation on page 835
Configuring the Protocol MTU PPPoE on page 835

Example: Configuring a PPPoE Client Interface on a J Series Services

Router on page 836
Example: Configuring a PPPoE Server Interface on an M120 or M320
Router on page 837
[edit interfaces interface-name]
:
:
ppp-over-ether-over-atm-llc
hierarchy
encapsulation