Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 1170

JUNOS 10.1 Network Interfaces Configuration Guide
frame-relay-ether-type-tcc
multilink-frame-relay-end-to-end
multilink-ppp
ppp-over-ether
ppp-over-ether-over-atm-llc
vlan-bridge
vlan-ccc
vlan-vci-ccc
vlan-tcc
vlan-vpls
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
1100
encapsulation (Logical Interface)
—Use Frame Relay ether type TCC for Cisco-compatible
Frame Relay on TCC circuits to connect unlike media. The physical interface
must be configured with flexible-frame-relay encapsulation.
is used only on multilink, link services, and voice services interfaces and their
constituent T1 or E1 interfaces.
—Use MLPPP encapsulation. This encapsulation is used only on multilink,
link services, and voice services interfaces and their constituent T1 or E1
interfaces.
—For underlying Ethernet interfaces on J Series Services Routers, use
PPP over Ethernet encapsulation. When you use this encapsulation type, you
cannot configure the interface address. Instead, configure the interface address
on the PPP interface. You also use PPP over Ethernet encapsulation to configure
an underlying Ethernet interface for a dynamic PPPoE logical interface on M120
and M320 Series routers with Intelligent Queuing 2 (IQ2) PICs, and on MX Series
routers with Trio MPC/MIC interfaces.
—For underlying ATM interfaces on J Series Services Routers
only, use PPP overEthernet over ATM LLC encapsulation. When you use this
encapsulation type, you cannot configure the interface address. Instead, configure
the interface address on the PPP interface.
—Use Ethernet VLAN bridge encapsulation on Ethernet interfaces that
have IEEE 802.1Q tagging, flexible-ethernet-services, and bridging enabled and
that must accept packets carrying TPID 0x8100 or a user-defined TPID.
—Use Ethernet virtual LAN (VLAN) encapsulation on CCC circuits. When you
use this encapsulation type, you can configure the
—Use ATM-to-Ethernet interworking encapsulation on CCC circuits. When
you use this encapsulation type, you can configure the
—Use Ethernet VLAN encapsulation on TCC circuits. When you use this
encapsulation type, you can configure the
—Use Ethernet VLAN encapsulation on VPLS circuits.
—Use MLFR FRF.15 encapsulation. This encapsulation
family only.
tcc
ccc family only.
ccc family only.