Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 602

JUNOS 10.1 Network Interfaces Configuration Guide
The 4-port Channelized OC3/STM1 Circuit Emulation PICs support T1 and E1 options
with the following exceptions:
Displaying Information About Circuit Emulation PICs
Use the CLI
configuration.
532
Displaying Information About Circuit Emulation PICs
and
crc-major-alarm-threshold
remote-loopback-respond is not supported. It is not applicable in SAToP
configurations.
,
bert-algorithm bert-error-rate
CE1 configurations only.
framing is supported for CT1 or CE1 configurations only. It is not applicable in
SAToP configurations.
is supported in CT1 configurations only.
buildout
is supported in CT1 configurations only.
line-encoding
loopback local and loopback remote
only. By default, no loopback is configured.
is not supported. It is not applicable in SAToP configurations.
loopback payload
idle-cycle-flag is not supported. It is not applicable in SAToP configurations.
is not supported. It is not applicable in SAToP configurations.
start-end-flag
invert-data is not supported. It is not applicable in SAToP configurations.
fcs16 is not supported in E1 and T1 configurations only.
is not supported in E1 and T1 configurations only. It is not applicable in
fcs32
SAToP configurations.
timeslots is not supported. It is not applicable in SAToP or ATM configurations.
is not supported in T1 configurations only. It is not applicable in
byte-encoding
SAToP configurations. nx56
and
crc-major-alarm-threshold
in SAToP configurations only.
remote-loopback-respond is not supported. It is not applicable in SAToP
configurations.
show chassis hardware
For a T1 Circuit Emulation PIC configuration, the output designation is
For an E1 Circuit Emulation PIC configuration, the output designation is
For a COC3 Circuit Emulation PIC configuration, the output designation is
.
CE
For a CSTM1 Circuit Emulation PIC configuration, the output designation is
.
CE
crc-minor-alarm-threshold
, and options are supported for CT1 or
bert-period
are supported in CE1 and CT1 configurations
byte encoding is not supported.
crc-minor-alarm-threshold
command to display information about the PIC
are not supported.
are T1 options supported
.
T1 CE
E1 CE .
COC1
CSTM1