Access-Concentrator - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

JUNOS 10.1 Network Interfaces Configuration Guide

access-concentrator

access-concentrator name;
Syntax
Hierarchy Level [edit interfaces interface-name unit logical-unit-number pppoe-options],
[edit interfaces interface-name unit logical-unit-number pppoe-underlying-options],
[edit logical-systems logical-system-name interfaces interface-name unit logical-unit-number
[edit logical-systems logical-system-name interfaces interface-name unit logical-unit-number
Statement introduced before JUNOS Release 7.4.
Release Information
Support at
pppoe-underlying-options]
interface-name unit logical-unit-number pppoe-underlying-options]
introduced in JUNOS Release 10.1.
For J Series Services Routers with Point-to-Point Protocol over Ethernet (PPPoE)
Description
interfaces, configure the name of the access concentrator.
For Intelligent Queuing 2 (IQ2) PICs on M120 and M320 routers and Trio MPC/MIC
interfaces on MX Series routers, configure an alternative access concentrator name
in the AC-NAME tag in a PPPoE control packet for use with a dynamic PPPoE
subscriber interface. If you do not configure the access concentrator name, the
AC-NAME tag contains the system name.
Options name
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics
948
access-concentrator
pppoe-options],
pppoe-underlying-options]
[edit interfaces interface-name unit logical-unit-number
and
—Name of the access concentrator.
Identifying the Access Concentrator on page 833
JUNOS Software Interfaces and Routing Configuration Guide
For information about creating dynamic PPPoE subscriber interfaces, see
Configuring Dynamic PPPoE Subscriber Interfaces Using Dynamic Profiles
[edit logical-systems logical-system-name interfaces
hierarchy levels