Callback-Wait-Period - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

JUNOS 10.1 Network Interfaces Configuration Guide

callback-wait-period

callback-wait-period time;
Syntax
Hierarchy Level [edit interfaces dln unit logical-unit-number dialer-options],
[edit logical-systems logical-system-name interfaces dln unit logical-unit-number
Statement introduced in JUNOS Release 7.5.
Release Information
On J Series Services Routers with interfaces configured for ISDN with callback, specify
Description
the amount of time the dialer waits before calling back the caller. The default wait
time is 5 seconds. The wait time is necessary because, when a call is rejected, the
switch waits for up to 4 seconds on point-to-multipoint connections to ensure no
other device accepts the call before sending the DISCONNECT message to the
originator of the call. However, the default time of 5 seconds may not be sufficient
for different switches or may not be needed on point-to-point connections.
To configure callback mode, include the
unit logical-unit-number dialer-options]
If the
at the
Options time
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics
1014
callback-wait-period
dialer-options]
callback statement is configured, you cannot use the
[edit interfaces dln unit logical-unit-number dialer-options]
—Time the dialer waits before calling back the caller.
Configuring Dial-In and Callback on page 884
JUNOS Software Interfaces and Routing Configuration Guide
callback statement at the
hierarchy level.
caller caller-id
hierarchy level.
[edit interfaces dln
statement