Atm Ima Configuration Overview; Ima Version; Ima Groups; Group Frame Size - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

The interfaces
To create an ATM interface on CAU4, enter the following command:
Or specify the following:
You can use the
PICs.

ATM IMA Configuration Overview

M7i, M10i, M40e, M120, and M320 routers with 4-port COC3 Circuit Emulation PICs
and 12-port T1/E1 Circuit Emulation PICs support inverse multiplexing over ATM
(IMA). The 12-port-T1/E1 PIC supports discrete T1 ATM IMA. The 4-port-COC3 PIC
supports channelized OC3/STM1 (down to T1) ATM IMA.
The 4-port COC3 Circuit Emulation PIC and 12-port T1/E1 Circuit Emulation PIC
support the ATM (IMA) protocol at the T1/E1 level with up to 4 IMA groups with from
2 to 8 IMA links each.
This section includes the following topics:
are created.
at-x/y/z:1:2
set interfaces cau4-fpc/pic/port partition 2 interface-type at
interfaces {
cau4-fpc/pic/port {
partition number {
interface-type at;
}
}
}
show chassis hardware
IMA Version on page 546
IMA Groups on page 546
Group Frame Size on page 546
IMA Clock Mode on page 546
IMA Group Symmetry on page 546
Minimum Active Links on page 546
State Transition Variables: Alpha, Beta, and Gamma on page 546
IMA Link Addition and Deletion on page 547
IMA Test Pattern Procedure on page 547
Per-PIC Limit on the Number of Links on page 547
IMA Group Alarms and Group Defects on page 547
IMA Link Alarms and Link Defects on page 548
IMA Group Statistics on page 549
IMA Link Statistics on page 550
IMA Clocking on page 551
Chapter 28: Configuring ATM Support on Circuit Emulation PICs
command to display a list of the installed
ATM IMA Configuration Overview
545