Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 836

JUNOS 10.1 Network Interfaces Configuration Guide
766
Example: One-Way Ethernet Frame Delay Measurement
Auto-discovery: enabled, Priority: 0
Interface name: ge-0/2/5.0, Interface status: Active, Link status: Up
Defects:
Remote MEP not receiving CCM
Erroneous CCM received
Cross-connect CCM received
RDI sent by some MEP
Statistics:
CCMs sent
CCMs received out of sequence
LBMs sent
Valid in-order LBRs received
Valid out-of-order LBRs received
LBRs received with corrupted data
LBRs sent
LTMs sent
LTMs received
LTRs sent
LTRs received
Sequence number of next LTM request
1DMs sent
Valid 1DMs received
Invalid 1DMs received
DMMs sent
DMRs sent
Valid DMRs received
Invalid DMRs received
Remote MEP count: 1
Identifier MAC address
201 00:90:69:0a:43:94
To display CFM database information for MEPs specified by interface name,
use the form of the
interfaces detail
connectivity-fault-management
ETH-DM frame counts.
In the example configuration for router
assigned to an interface on the router. Therefore, the
connectivity-fault-management interfaces
displays CFM database information for MEP
not filter the command output by including the
level md-level command options.
user@MX-PE2> show oam ethernet connectivity-fault-management interfaces
detail
Interface name: ge-0/2/5.0, Interface status: Active, Link status: Up
Maintenance domain name: md6, Format: string, Level: 6
Maintenance association name: ma6, Format: string
Continuity-check status: enabled, Interval: 100ms, Loss-threshold: 3
frames
MEP identifier: 101, Direction: down, MAC address: 00:90:69:0a:48:57
MEP status: running
Defects:
Remote MEP not receiving CCM
Erroneous CCM received
Cross-connect CCM received
RDI sent by some MEP
Statistics:
: no
: no
: no
: no
: 1590
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 10
: 0
: 0
: 0
: 0
: 0
: 0
State Interface
ok ge-0/2/5.0
show oam ethernet
command. A CFM database also stores any
, MEP
MX-PE2 101
show oam ethernet
( |
detail extensive
only, even though you do
101
ethernet-interface-name
: no
: no
: no
: no
is the only MEP
) command output
or