Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 436

JUNOS 10.1 Network Interfaces Configuration Guide
Table 31: ATM-over-ADSL Operational Modes (continued)
Configuring the ATM-over-ADSL Physical Interface Encapsulation Type
Configure the physical interface encapsulation type by including the
statement at the
Table 32 on page 367 shows the physical interface encapsulation types for
ATM-over-ADSL interfaces.
Configuring the ATM-over-ADSL Logical Interface Encapsulation Type
Configure the logical interface encapsulation type by including the
statement:
You can include this statement at the following hierarchy levels:
[edit interfaces interface-name unit logical-unit-number]
[edit logical-systems logical-system-name interfaces interface-name unit logical-unit-number]
Table 32 on page 367 shows the logical interface encapsulation types for
ATM-over-ADSL interfaces.
366
Configuring the ATM-over-ADSL Physical Interface Encapsulation Type
Encapsulation Types
Annex B PIMs
adsl2plus
auto
etsi
itu-dmt
itu-dmt-bis
itu-annexb-ur2
itu-annexb-non-ur2
itu-dmt
[edit interfaces at-pim/0/port]
[edit interfaces at-pim/0/port]
encapsulation type;
[edit interfaces at-pim/0/port unit logical-unit-number]
encapsulation type;
Comments
Set the ADSL line to train in the ITU G.992.5 mode.
Set the ADSL line after autonegotiating the setting to
match the setting of the DSLAM located at the central
office.
Set the ADSL line to train in the ETSI TS 101 388 V1.3.1
mode.
Set the ADSL line to train in the ITU G.992.1 mode.
Set the ADSL line to train in the ITU G.992.3 mode.
Set the ADSL line to train in the ITU G.992.1 Deutsche
Telekom UR-2 mode.
Set the ADSL line to train in the ITU G.992.1 non-UR-2
mode.
Set the ADSL line to train in the ITU G.992.1 mode.
hierarchy level:
encapsulation
encapsulation