Idle-Cycle-Flag - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

JUNOS 10.1 Network Interfaces Configuration Guide

idle-cycle-flag

idle-cycle-flag value;
Syntax
Hierarchy Level [edit interfaces e1-fpc/pic/port],
[edit interfaces t1-fpc/pic/port],
[edit interfaces interface-name ds0-options],
[edit interfaces interface-name e1-options],
[edit interfaces interface-name e3-options],
[edit interfaces interface-name serial-options],
[edit interfaces interface-name t1-options],
[edit interfaces interface-name t3-options]
Statement introduced before JUNOS Release 7.4.
Release Information
Configure the value that the DS0, E1, E3, T1, or T3 interface transmits during idle
Description
cycles.
NOTE: When configuring E1 or T1 interfaces on 10-port Channelized E1/T1 IQE PICs,
the
or
value
Options
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics
1158
idle-cycle-flag
statement must be included at the
idle-cycle-flag
[edit interfaces t1-fpc/pic/port]
—Value to transmit in the idle cycles:
flags —Transmit the value 0x7E.
ones —Transmit the value 0xFF (all ones).
Default:
Flags
Configuring the E1 Idle Cycle Flag on page 564
Configuring the E3 Idle Cycle Flag on page 573
Configuring the T1 Idle Cycle Flag on page 584
Configuring the T3 Idle Cycle Flag on page 593
[edit interfaces e1-fpc/pic/port]
hierarchy level as appropriate.