Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 302

JUNOS 10.1 Network Interfaces Configuration Guide
Configuring ATM Circuits
For ATM circuits, include the
hierarchy level:
On the logical interface, include the following statements:
You can include the logical interface statements at the following hierarchy levels:
For each VC, configure whether it is a circuit or a regular logical interface. The default
interface type is point-to-point.
Configuring Frame Relay Circuits
For Frame Relay circuits, include the
interface-name]
On the logical interface, include the following statements:
You can include the logical interface statements at the following hierarchy levels:
232
Defining the Encapsulation for Switching Cross-Connects
[edit interfaces interface-name]
encapsulation (ppp-ccc | cisco-hdlc-ccc | ppp-tcc | cisco-hdlc-tcc);
unit 0;
[edit interfaces at-fpc/pic/port]
atm-options {
vpi vpi-identifier;
}
point-to-point;
encapsulation (atm-ccc-cell-relay | atm-ccc-vc-mux | atm-tcc-vc-mux | atm-tcc-snap);
vci vpi-identifier.vci-identifier;
[edit interfaces at-fpc/pic/port unit logical-unit-number]
[edit logical-systems logical-system-name interfaces at-fpc/pic/port unit
logical-unit-number]
hierarchy level:
[edit interfaces interface-name]
encapsulation type;
point-to-point;
encapsulation type;
dlci dlci-identifier;
[edit interfaces interface-name unit logical-unit-number]
[edit logical-systems logical-system-name interfaces interface-name unit
logical-unit-number]
vpi statement [edit interfaces interface-name atm-options]
encapsulation statement at the [edit interfaces