Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 1256

JUNOS 10.1 Network Interfaces Configuration Guide
transmit-period
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics
interface (IEEE 802.1ag OAM Connectivity-Fault Management)
interface (interface-name | ((ge- | xe-) (fpc/pic/port | fpc/pic/port.unit-number |
Syntax
[edit protocols oam ethernet connectivity-fault-management maintenance-domain
Hierarchy Level
Statement introduced in JUNOS Release 8.4.
Release Information
For Ethernet interfaces on M320, MX Series, and T Series routers, configure IEEE
Description
802.1ag Operation, Administration, and Management (OAM) support.
For Gigabit Ethernet interfaces and 10-Gigabit Ethernet interfaces on MX Series
routers, configure IEEE 802.1ag Connectivity Fault Management (CFM) support on
trunk interface ports.
interface-name
Options
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics
1186
interface (IEEE 802.1ag OAM Connectivity-Fault Management)
—Specify the number of seconds the port waits before retransmitting
the initial EAPOL PDUs to the client.
IEEE 802.1x Port-Based Network Access Control Overview on page 771
authenticator on page 985
dot1x on page 1078
fpc/pic/port.unit-number vlan vlan-id)));
domain-name maintenance-association ma-name mep mep-id]
—Interface to which the MEP is attached. It could be a physical Ethernet
interface, logical Ethernet interface, or on a specific VLAN of a trunk port interface
(MX Series only).
Configuring the Maintenance End Point Interface
Example: Configuring Connectivity Fault Management for a PBB Network on MX
Series Routers