Cbit-Parity - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

cbit-parity

(cbit-parity | no-cbit-parity);
Syntax
[edit interfaces interface-name t3-options]
Hierarchy Level
Statement introduced before JUNOS Release 7.4.
Release Information
For T3 interfaces only, enable or disable C-bit parity mode, which controls the type
Description
of framing that is present on the transmitted T3 signal. When C-bit parity mode is
enabled, the C-bit positions are used for the far-end block error (FEBE), far-end alarm
and control (FEAC), terminal data link, path parity, and mode indicator bits, as defined
in ANSI T1.107a-1989. For ATM and ATM2 IQ2 and IQ2-E interfaces, M23 framing
is used when the
framing is used when the
C-bit parity mode is enabled.
Default
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics
no-cbit-parity
no-cbit-parity
Configuring E3 and T3 Parameters on ATM Interfaces on page 345
Disabling T3 C-Bit Parity Mode on page 589
Chapter 62: Summary of Interface Configuration Statements
statement is included. For all other interfaces, M13
statement is included.
1017
cbit-parity