Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 344

JUNOS 10.1 Network Interfaces Configuration Guide
Invalid EIA-530 Interface Statements
If you do not include the
default EIA-530 line protocol, the following statements are invalid:
You can include the line-protocol statement at the following hierarchy levels:
Invalid V.35 interface Statements
If you include the
You can include the line-protocol statement at the following hierarchy levels:
Invalid X.21 Interface Statements
If you include the
274
Configuring the Serial Line Protocol
line-protocol
dce-options | dte-options {
control-signal (assert | de-assert | normal);
indication (ignore | normal | require);
}
control-polarity (negative | positive);
indication-polarity (negative | positive);
[edit interfaces se-pim/0/port serial-options]
[edit interfaces se-fpc/pic/port serial-options]
line-protocol v.35
dce-options | dte-options {
control-signal (assert | de-assert | normal);
indication (ignore | normal | require);
tm (ignore | normal | require);
}
control-polarity (negative | positive);
indication-polarity (negative | positive);
loopback (dce-local | dce-remote);
tm-polarity (negative | positive);
[edit interfaces se-pim/0/port serial-options]
[edit interfaces se-fpc/pic/port serial-options]
line-protocol x.21
dce-options | dte-options {
cts (ignore | normal | require);
dcd (ignore | normal | require);
dsr (ignore | normal | require);
dtr (assert | de-assert | normal);
rts (assert | de-assert | normal);
tm (ignore | normal | require);
}
clocking-mode (dce | internal);
cts-polarity (negative | positive);
dce-polarity (negative | positive);
statement or if you explicitly configure the
statement, the following statements are invalid:
statement, the following statements are invalid: