Table of Contents
Advertisement
Chapter 35
Configuring Aggregated Ethernet
Interfaces
Aggregated Ethernet Interfaces Overview
Aggregated Ethernet Interfaces Overview on page 643
Configuring an Aggregated Ethernet Interface on page 645
Deleting an Aggregated Ethernet Interface on page 646
Configuring Multi-Chassis Link Aggregation on page 646
Configuring Aggregated Ethernet Link Protection on page 647
Configuring the Number of Aggregated Ethernet Interfaces on the
Device on page 649
Configuring Aggregated Ethernet LACP on page 649
Configuring Untagged Aggregated Ethernet Interfaces on page 655
Configuring Aggregated Ethernet Link Speed on page 656
Configuring Aggregated Ethernet Minimum Links on page 657
Configuring Hierarchical Scheduler on Aggregated Ethernet Interfaces Without
Link Protection on page 657
Configuring Symmetrical Load Balancing on an 802.3ad Link Aggregation Group
on MX Series Routers on page 658
Link aggregation of Ethernet interfaces is defined in the IEEE 802.3ad standard. The
JUNOS implementation of 802.3ad balances traffic across the member links within
an aggregated Ethernet bundle based on the Layer 3 information carried in the packet.
This implementation uses the same load-balancing algorithm used for per-packet
load balancing. For information about per-packet load balancing, see the JUNOS
Routing Protocols Configuration Guide.
NOTE: For information about configuring circuit cross-connects over aggregated
Ethernet, see "Circuit and Translational Cross-Connects Overview" on page 229.
Aggregated Ethernet Interfaces Overview
643
Advertisement
Table of Contents
