JUNOS 10.1 Network Interfaces Configuration Guide
Example: Configuring ATM-to-Ethernet Interworking
The following example shows the configuration of the ATM and Ethernet interfaces
for an ATM-to-Ethernet interworking cross connect. In the example ATM DSLAM
traffic is terminated on an ATM2 interface. The ATM traffic is forwarded using
encapsulation type
topology in Figure 15 on page 246.
Figure 15: ATM-to-Ethernet Interworking
In this example, the ATM traffic comes from the DSLAM to the router on ATM interface
at-4/0/0
246
Example: Configuring ATM-to-Ethernet Interworking
}
}
}
vlan-vci-ccc
and is forwarded out on Ethernet interface
[edit interfaces]
ge-2/2/1 {
vlan-vci-tagging;
encapsulation vlan-vci-ccc;
unit 0 {
encapsulation vlan-vci-ccc;
vlan-id 100;
inner-vlan-id-range start 100 end 500;
}
}
at-4/0/0 {
atm-options {
vpi 100;
}
unit 0 {
encapsulation vlan-vci-ccc;
family ccc;
vpi 100;
vci-range start 100 end 500;
}
}
to a local Ethernet IQ2 and IQ2-E interface. See the
ge-2/2/1
.