Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 360

JUNOS 10.1 Network Interfaces Configuration Guide
ATM1 Physical and Logical Configuration Statement Hierarchies
To configure ATM1 physical interface properties, include the
t3-options
level:
ATM1 Physical
Configuration Hierarchy
290
ATM1 Physical and Logical Configuration Statement Hierarchies
Example: Configuring ATM1 Interfaces on page 358
Example: Configuring ATM2 IQ Interfaces on page 360
, and sonet-options
[edit interfaces at-fpc/pic/port]
atm-options {
ilmi;
mpls {
pop-all-labels {
required-depth number;
}
}
pic-type atm1;
promiscuous-mode {
vpi vpi-identifier;
}
vpi vpi-identifier {
maximum-vcs maximum-vcs;
}
}
e3-options {
atm-encapsulation (direct | plcp);
buildout feet;
framing (g.751 | g.832);
loopback (local | remote);
(payload-scrambler | no-payload-scrambler);
}
encapsulation (atm-ccc-cell-relay | atm-pvc | ethernet-over-atm);
sonet-options {
aps {
advertise-interval milliseconds;
authentication-key key;
force;
hold-time milliseconds;
lockout;
neighbor address;
paired-group group-name;
protect-circuit group-name;
request;
revert-time seconds;
working-circuit group-name;
}
bytes {
e1-quiet value;
f1 value;
f2 value;
s1 value;
statements at the [edit interfaces at-fpc/pic/port]
, ,
atm-options e3-options
hierarchy