Configuring Sonet/Sdh Framing - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

protect-circuit group-name;
request;
revert-time seconds;
switching-mode (bidirectional | unidirectional);
working-circuit group-name;
}
bytes {
e1-quiet value;
f1 value;
f2 value;
s1 value;
z3 value;
z4 value;
}
fcs (16 | 32);
loopback (local | remote);
mpls {
pop-all-labels {
required-depth number;
}
}
path-trace trace-string;
(payload-scrambler | no-payload-scrambler);
rfc-2615;
trigger {
defect ignore;
defect hold-time up milliseconds down milliseconds;
}
}
vtmapping (itu-t | klm);
(z0-increment | no-z0-increment);
speed (oc3 | oc12 | oc48);
Note that when you configure SONET/SDH OC48 interfaces for channelized
(multiplexed) mode (by including the
fpc slot-number pic pic-number]
Currently, the bytes e1-quiet
The , ,
bytes f2 bytes z3 bytes z4
and work in the transmit direction only on channels 1, 2, and 3. When using
no-concatenate , you must specify a channel. For more information, see the JUNOS
System Basics Configuration Guide.
For DS3 channels on a channelized OC12 interface, the
and bytes z4 options have no effect. The
0; it is ignored if configured on channels 1 through 11. The
on channel 0 applies to all channels on the interface.
You can also include some of the statements in the
SONET/SDH parameters on ATM interfaces.
You can configure the following SONET/SDH physical interface properties:
Configuring SONET/SDH Framing on page 898
Configuring SONET/SDH Interface Speed on page 899
Chapter 61: Configuring SONET/SDH Interfaces
no-concatenate
hierarchy level), the
bytes f1
statement is ignored if you include it in the configuration.
, and options work correctly on channel 0
path-trace
bytes s1 option is supported only for channel
sonet-options
Configuring SONET/SDH Physical Interface Properties
statement at the [edit chassis
statement has no effect.
, ,
bytes f1 bytes f2 bytes z3
value configured
bytes s1
statement to set
,
897